RSH dimensions...again
Posted: Wed Mar 12, 2014 12:39 am
Ok seems like this topic is beat to death but I do have a question on dimensions. I have a 25 gallon propane tank that I wanted to use for the shroud (or whatever you call it) for a 6" stove. It's about 40" tall with a 14" inner diameter. Looks like most of you guys are using that kind of dimension for the outer layer of a cast riser not the outer shroud. I was thinking of casting my riser from a 6" sonotube or stove pipe nested in a 12" sonotube. That's 3" wall thickness on that riser but that only leaves 2" between the riser and the shroud. Is this doable? I like the aesthetics of these dimensions better than a typical 55 gal barrel stove but is there a good way to get the exhaust out of that tank? Thanks for any advice.